Sponsored Advertisement

Babies swallow bath water, which makes the tub a lead question

The exposure route is ingestion, not skin. And in older buildings the bathroom is often on a different branch than the kitchen.

Infant-focused water safety

Testing can address lead, bacteria and other selected concerns without relying on taste or appearance.

Sample the water actually used

Kitchen taps, refrigerator lines and selected filtered outlets can be tested when relevant to the family's concern.

Accredited laboratory analysis

Results provide measured information for the specific contaminants included in the testing scope.

New York

(212) 461-3879

New Jersey

(908) 772-8601

Connecticut

(203) 780-2022

NELAP accredited laboratory analysis

Certified Master Inspector

Water Quality Association

AIHA member

Serving NY, NJ and CT since 1991

Questions clients commonly ask

Request professional water testing

Send the details and a specialist will respond.

Olympian Water Testing | Sponsored Listing on Infant Safety Guide
35Years in operation
5New York City locations
3States served
24/7Water-testing support
Formula & foodTap water used for infant formula, drinks and food preparation can be tested directlyPoint-of-use testing
No warningLead in drinking water cannot be identified reliably by color, taste or smellLaboratory testing required
Test the outletResults describe the specific sampled tap and conditions, not every fixture in the propertySampling matters
BusinessOlympian Water Testing LLC
CategoryWater Testing Service, independent laboratory analysis
Established1991, 35 years in operation
Service areaNew York, New Jersey and Connecticut
LocationsFive departure locations across New York City
Telephone(212) 461-3879 New York  •  (908) 772-8601 New Jersey  •  (203) 780-2022 Connecticut
Website olympianwatertesting.com
PanelsLead, copper, bacteria, PFAS, chemicals and full potability
AnalysisNELAP accredited laboratory analysis, accredited results provided
Locations

Five departure locations

Brooklyn
665 88th Street, Brooklyn, NY 11228
(718) 766-7043
Sunnyside
47-1 Greenpoint Avenue, Sunnyside, NY 11104
(718) 819-1230
Upper West Side
461 Columbus Avenue, New York, NY 10024
(212) 461-3879
Staten Island
1365 North Railroad Avenue, Staten Island, NY 10306
(212) 461-3879
Midtown
350 5th Avenue, New York, NY 10118
(646) 328-2931
Bath and drinking water testing

Babies swallow bath water, which makes the tub a lead question

01
Count every cold water point
Kitchen, bathrooms, utility sink, outside tap and any accessory line. The count is almost always higher than families expect.
02
Mark the ones the child meets
Where bottles are made, where bottles are washed, the tub, and anything used to rinse a pacifier or a toy.
03
Check whether they share a branch
In older housing the kitchen and bathroom frequently sit on separate runs and can return different lead results.
04
Fix the standing period in advance
The household agrees not to draw water from the previous evening and the elapsed hours go into the field record.
05
Draw the sequence with screens on
Bottles filled in order along the supply path, outlet screens undisturbed, every point documented.

Lead in Water Testing for Drinking and Bath Water

Household safety guidance addresses bath water as a temperature and supervision matter. For lead, the relevant consideration is different: the exposure route for an infant is ingestion, because bath water is swallowed and washcloths are mouthed.

Olympian Water Testing carries out professional lead in water testing for families with infants and young children across New York, New Jersey and Connecticut.

Why the Tub Is a Separate Question

In many properties the kitchen and the bathroom sit on different branch lines and were altered at different times, so the two can return different values.

A household that assessed the kitchen alone has established the position at one of the two taps a child actually meets.

Where Lead Enters

The pathways are the water service line, lead tin solder used at pipe joints, and brass components distributed throughout the supply path.

Lead can be present in current components such as tub and shower mixing valves, water heater nipples and relief valves, faucet cartridge housings and stems, angle stops and shutoff valves beneath sinks and behind appliances, brass pipe fittings including tees, elbows, couplings, unions and adapters, hose bibbs and exterior spigots, well pump and booster pump wetted components, ball and gate valves on domestic hot and cold isolation, backflow preventers and pressure reducing valves. Such fixtures return measurable lead when the water is analyzed, which is why assessment is not gated on when a property was built.

How the Sampling Event Is Conducted

Our highly trained and skilled laboratory technicians perform the site visit and identify every cold water point of use, and the household confirms which points a child meets.

Lead is drawn as an ordered series, a stagnation period is requested from the client where the parameter requires it, and outlet screens are left undisturbed.

Understanding Our Reporting

Our reporting identifies each sampling point, the method applied, the reporting limit and the measured concentration.

Blood lead analysis is a clinical matter and answers a different question entirely. Olympian Water Testing has operated since 1991 under NELAP accredited laboratory analysis.

How Olympian works

What Olympian does
  • On site sample collection by our highly trained and skilled laboratory technicians
  • Stagnation instructions provided in advance when required by the selected test
  • Chain of custody maintained from collection through analysis
  • NELAP accredited laboratory analysis
  • Our reporting states methods, reporting limits and measured values
Why clients choose Olympian
  • Thirty five years serving New York, New Jersey and Connecticut
  • Parameter selection determined through consultation with our consultants
  • Five departure locations across New York City
  • Reporting limits stated for every parameter selected
  • Support available 24/7 for testing questions and scheduling

Common questions

What water-safety concerns are most relevant for infants?
Families commonly ask about lead, bacteria and the overall quality of the water used for drinking and formula. Private-well owners may have additional groundwater-related concerns.
Can infant drinking water look normal and still contain lead?
Yes. Lead is not identified by color, taste or smell, so testing is required to determine whether it is present.
Should a daycare or childcare facility test drinking-water outlets?
Testing can be designed for childcare facilities, including fountains, classroom sinks, kitchen outlets and other locations selected under the applicable program or concern.
Can water testing include both the home and childcare setting?
Yes. They are separate water environments and can be sampled independently when a family or facility wants information about both.

Request Water Testing for Your Family

Tell Olympian what you want to understand about the home's water, and the testing can be built around your specific questions and concerns.

Request Water Testing for Your Family